On the robustness of stable turning processes
- 期刊名称International Journal of Machining and Machinability of Materials
- 作者Dombovari, Zoltan; Wilson, R. Eddie; Stepan, Gabor
- 卷第4卷
- 期第4期
- 印刷ISSN1748-5711
- 电子ISSN1748-572X
- 文件大小1295.29KB
- 发表时间2008
- DOI10.1504/ijmmm.2008.023716
Offline adaptive controlKarunakaran, K.P.; Shah, Mihir; Shringi, R.; Bernard, A.; Arrazola, P.J. · International Journal of Machining and Machinability of Materials · 2010
An opening historical noteAstakhov, Viktor P. · International Journal of Machining and Machinability of Materials · 2006
Tool wear mechanisms in machiningYume, Jorge A. Olortegui; Kwon, Patrick Y. · International Journal of Machining and Machinability of Materials · 2007
Machining residual stresses and part distortionsZamashchikov, Yury I. · International Journal of Machining and Machinability of Materials · 2007
Cutting forces measurements during discontinuous machining processBenmohammed, B. · International Journal of Machining and Machinability of Materials · 2012
Metal cutting modelling SPH approachLimido, J.; Espinosa, C.; Salaun, M.; Mabru, C.; Chieragatti, R.; Lacome, J.L. · International Journal of Machining and Machinability of Materials · 2011
Optimisation of EDC parameters using TOPSIS approachSenthilkumar, C. · International Journal of Machining and Machinability of Materials · 2019
Prevention of wire breakage in wire EDMKumar, Rajnish; Choudhury, S.K. · International Journal of Machining and Machinability of Materials · 2011