Edge detection using fractal imaging
- 期刊名称International Journal of Mathematical Modelling and Numerical Optimisation
- 作者Demers, Matthew
- 卷第3卷
- 期第4期
- 印刷ISSN2040-3607
- 电子ISSN2040-3615
- 文件大小817.92KB
- 发表时间2012
- DOI10.1504/ijmmno.2012.049602
Drilling analytical model of composite material with pilot holeRahme, Pierre; Landon, Yann; Piquet, Robert; Lachaud, Frederic; Lagarrigue, Pierre · Mechanics & Industry · 2016
Study into causes of damage to carbon epoxy composite material during the drilling processRahme, Pierre; Landon, Yann; Lagarrigue, Pierre; Lachaud, Frederic; Piquet, Robert · International Journal of Machining and Machinability of Materials · 2008
Offline adaptive controlKarunakaran, K.P.; Shah, Mihir; Shringi, R.; Bernard, A.; Arrazola, P.J. · International Journal of Machining and Machinability of Materials · 2010
An opening historical noteAstakhov, Viktor P. · International Journal of Machining and Machinability of Materials · 2006
Tool wear mechanisms in machiningYume, Jorge A. Olortegui; Kwon, Patrick Y. · International Journal of Machining and Machinability of Materials · 2007
Machining residual stresses and part distortionsZamashchikov, Yury I. · International Journal of Machining and Machinability of Materials · 2007
Cutting forces measurements during discontinuous machining processBenmohammed, B. · International Journal of Machining and Machinability of Materials · 2012
Metal cutting modelling SPH approachLimido, J.; Espinosa, C.; Salaun, M.; Mabru, C.; Chieragatti, R.; Lacome, J.L. · International Journal of Machining and Machinability of Materials · 2011
Optimisation of EDC parameters using TOPSIS approachSenthilkumar, C. · International Journal of Machining and Machinability of Materials · 2019
Prevention of wire breakage in wire EDMKumar, Rajnish; Choudhury, S.K. · International Journal of Machining and Machinability of Materials · 2011